OpenLegislation

Division 4.4.3.1 Calculation process

Original text. Later amendments are not shown.

Arithmetic average velocity vjm, in km/h, and arithmetic average torque Cjm, in Nm, of each measurement shall be calculated from the data sets collected in paragraph 4.4.2.2. of this Sub-Annex using the following equations:

vjm=1k∑i= 1kvji

and

Cjm=1k∑i= 1kCji− Cjs

where:

vji
  • is the actual vehicle speed of the ith data set at reference speed point j, km/h;

  • k
  • is the number of data sets in a single measurement;

  • Cji
  • is the actual torque of the ith data set, Nm;

  • Cjs
  • is the compensation term for speed drift, Nm, given by the following equation:

  • Cjs=mst+ mr× αjrj.

    Cjs1k∑ki= 1Cji shall be no greater than 0,05 and may be disregarded if αj is not greater than ± 0,005 m/s2;

    mst
  • is the test vehicle mass at the start of the measurements and shall be measured immediately before the warm-up procedure and no earlier, kg;

  • mr
  • is the equivalent effective mass of rotating components according to paragraph 2.5.1. of this Sub-Annex, kg;

  • rj
  • is the dynamic radius of the tyre determined at a reference point of 80 km/h or at the highest reference speed point of the vehicle if this speed is lower than 80 km/h, calculated according to the following equation:

    rj=13,6×vjm2× πn
  • where:

    n
  • is the rotational frequency of the driven tyre, s-1;

  • αj
  • is the arithmetic average acceleration, m/s2, which calculated using the following equation:

    αj=13,6×k∑ki= 1tivji−∑ki= 1ti∑ki= 1vjik×∑ki= 1t2i−∑ki= 1ti2

    where:

    ti
  • is the time at which the ith data set was sampled, s.