OpenLegislation

Division 4.1.1.1 Stepwise procedure for calculating the final test results of the charge-sustaining Type 1 test for NOVC-HEVs and OVC-HEVsF1

Original text. Later amendments are not shown.

The results shall be calculated in the order described in Table A8/5. All applicable results in the column ‘Output’ shall be recorded. The column ‘Process’ describes the paragraphs to be used for calculation or contains additional calculations.

For the purpose of this table, the following nomenclature within the equations and results is used:

c
  • complete applicable test cycle;

  • p
  • every applicable cycle phase;

  • i
  • applicable criteria emission component (except CO2);

  • CS
  • charge-sustaining

  • CO2
  • CO2 mass emission.

  • Table A8/5
    Calculation of final charge-sustaining gaseous emission values
    SourceInputProcessOutputStep No.
    Sub-Annex 6Raw test results

    Charge-sustaining mass emissions

    Paragraphs 3. to 3.2.2. of Sub-Annex 7.

    Mi,CS,p,1, g/km; MCO2,CS,p,1, g/km.1
    Output from step No. 1 of this table.Mi,CS,p,1, g/km; MCO2,CS,p,1, g/km.

    Calculation of combined charge-sustaining cycle values:

    Mi,CS,c,2=∑pMi,CS,p,1×dp∑pdpMCO2,CS,c,2=∑pMCO2,CS,p,1×dp∑pdp

    where:

    • Mi,CS,c,2 is the charge-sustaining mass emission result over the total cycle;

    • MCO2,CS,c,2 is the charge-sustaining CO2 mass emission result over the total cycle;

    • dp are the driven distances of the cycle phases p.

    Mi,CS,c,2, g/km; MCO2,CS,c,2, g/km.2
    Output from steps Nos. 1 and 2 of this table.MCO2,CS,p,1, g/km; MCO2,CS,c,2, g/km.

    REESS electric energy change correction

    Paragraphs 4.1.1.2. to 4.1.1.5. of this Sub-Annex.

    MCO2,CS,p,3, g/km; MCO2,CS,c,3, g/km.3
    Output from steps Nos. 2 and 3 of this table.Mi,CS,c,2, g/km; MCO2,CS,c,3, g/km.

    Charge-sustaining mass emission correction for all vehicles equipped with periodically regenerating systems Ki in accordance with Sub-Annex 6, Appendix 1.

    Mi,CS,c,4 = Ki × Mi,CS,c,2

    or

    Mi,CS,c,4 = Ki + Mi,CS,c,2

    and

    MCO2,CS,c,4=KCO2,Ki×MCO2,CS,c,3

    or

    MCO2,CS,c,4=KCO2,Ki+MCO2,CS,c,3

    Additive offset or multiplicative factor to be used in accordance with Ki determination.

    If Ki is not applicable:

    • Mi,CS,c,4 = Mi,CS,c,2

    • MCO2,CS,c,4 = MCO2,CS,c,3

    Mi,CS,c,4, g/km; MCO2,CS,c,4, g/km.4a
    Output from steps Nos. 3 and 4a of this table.MCO2,CS,p,3, g/km; MCO2,CS,c,3, g/km; MCO2,CS,c,4, g/km.

    If Ki is applicable, align CO2 phase values to combined cycle value:

    MCO2,CS,p,4 = MCO2,CS,p,3 × AFKi

    for every cycle phase p;

    where:

    AFKi=MCO2,CS,c,4MCO2,CS,c,3

    If Ki is not applicable:

    MCO2,CS,p,4 = MCO2,CS,p,3

    MCO2,CS,p,4, g/km.4b
    Output from step No. 4 of this table.Mi,CS,c,4, g/km; MCO2,CS,p,4, g/km; MCO2,CS,c,4, g/km;

    ATCT correction in accordance with paragraph 3.8.2. of Sub-Annex 6a.

    Deterioration factors calculated and applied in accordance with Annex VII.

    Mi,CS,c,5, g/km; MCO2,CS,c,5, g/km; MCO2,CS,p,5, g/km.

    5

    Result of a single test.

    Output from step No. 5 of this table.For every test: Mi,CS,c,5, g/km; MCO2,CS,c,5, g/km; MCO2,CS,p,5, g/km.Averaging of tests and declared value in accordance with paragraphs 1.2. to 1.2.3. of Sub-Annex 6.Mi,CS,c,6, g/km; MCO2,CS,c,6, g/km; MCO2,CS,p,6, g/km; MCO2,CS,c,declared, g/km.

    6

    Mi,CS results of a Type 1 test for a test vehicle.

    Output from step No. 6 of this table.MCO2,CS,c,6, g/km; MCO2,CS,p,6, g/km; MCO2,CS,c,declared, g/km.

    Alignment of phase values.

    Paragraph 1.2.4. of Sub-Annex 6,

    and:

    MCO2,CS,c,7 = MCO2,CS,c,declared

    MCO2,CS,c,7, g/km; MCO2,CS,p,7, g/km.

    7

    MCO2,CS results of a Type 1 test for a test vehicle.

    Output from steps Nos. 6 and 7 of this table.

    For each of the test vehicles H and L:

    Mi,CS,c,6, g/km; MCO2,CS,c,7, g/km; MCO2,CS,p,7, g/km.

    If in addition to a test vehicle H a test vehicle L and, if applicable vehicle M was also tested, the resulting criteria emission value shall be the highest of the two or, if applicable, three values and referred to as Mi,CS,c.

    In the case of the combined THC + NOx emissions, the highest value of the sum referring to either the vehicle H or vehicle L or, if applicable, vehicle M is to be declared.

    Otherwise, if no vehicle L or if applicable vehicle M was tested, Mi,CS,c = Mi,CS,c,6

    For CO2 the values derived in step 7 of this Table shall be used.

    CO2 values shall be rounded to two decimal places.

    Mi,CS,c, g/km; MCO2,CS,c,H, g/km; MCO2,CS,p,H, g/km;

    If a vehicle L was tested:

    MCO2,CS,c,L, g/km; MCO2,CS,p,L, g/km;

    and, if applicable, a vehicle M was tested:

    MCO2,CS,c,M, g/km; MCO2,CS,p,M, g/km;

    8

    Interpolation family result.

    Final criteria emission result.

    Output from step No. 8 of this table.

    MCO2,CS,c,H, g/km; MCO2,CS,p,H, g/km;

    If a vehicle L was tested:

    MCO2,CS,c,L, g/km; MCO2,CS,p,L, g/km

    and, if applicable, a vehicle M was tested:

    MCO2,CS,c,M, g/km; MCO2,CS,p,M, g/km;

    CO2 mass emission calculation in accordance with paragraph 4.5.4.1. of this Sub-Annex for individual vehicles in an interpolation family.

    CO2 values shall be rounded in accordance with Table A8/2.

    MCO2,CS,c,ind, g/km; MCO2,CS,p,ind, g/km.

    9

    Result of an individual vehicle.

    Final CO2 result.

    Annotations

    Textual amendments

    F1

    Substituted by Commission Regulation (EU) 2018/1832 of 5 November 2018 amending Directive 2007/46/EC of the European Parliament and of the Council, Commission Regulation (EC) No 692/2008 and Commission Regulation (EU) 2017/1151 for the purpose of improving the emission type approval tests and procedures for light passenger and commercial vehicles, including those for in-service conformity and real-driving emissions and introducing devices for monitoring the consumption of fuel and electric energy (Text with EEA relevance).