Commission Implementing Regulation (EU) 2020/1425 of 8 October 2020 granting a Union authorisation for the biocidal product family ‘PeridoxRTU Product Family’ (Text with EEA relevance)

PeridoxRTU Product Family

Product type 2 – Disinfectants and algaecides not intended for direct application to humans or animals (Disinfectants)

Authorisation number: EU-0023658-0000

R4BP asset number: EU-0023658-0000

For use only on visibly clean surfaces. Cleaning prior to disinfection is required. Physically remove contaminants from the surface before disinfection using a suitable cleanroom wipe and a recommended wiping technique for optimum contamination control.

Spray directly onto a suitable cleanroom wipe. Use a wipe to distribute the liquid on the surface.

Ensure the surface is uniformly covered with the product and leave for the required contact time indicated to kill bacteria, fungi, yeast and bacterial spores.

Do not apply more than 50 ml/m².

Leave for required contact time and wipe to dry afterwards.

For use at room temperature (20 ± 2 °C).

Suitable cleanroom wipe materials should be used in order to minimise interaction with the product.

Used wipes must be disposed in a closed container.

Wear protective chemical resistant gloves and eye protection during product handling phase (glove material to be specified by the authorisation holder within the product information)

A protective coverall which is impermeable for the biocidal product shall be worn (coverall material to be specified by the authorisation holder within the product information).

A ventilation rate of at least 20/hr is mandatory when handling the product.

The product must only be applied for disinfection of small surfaces.

Inhalation: Move affected person to fresh air and keep warm and at rest in a position comfortable for breathing. Maintain an open airway. Loosen tight clothing such as collar, tie or belt. When breathing is difficult, properly trained personnel may assist affected person by administering oxygen. Get medical attention. Place unconscious person on their side in the recovery position and ensure breathing can take place.

Skin contact: It is important to remove the substance from the skin immediately. Rinse immediately with plenty of water. Continue to rinse for at least 15 minutes and get medical attention. Chemical burns must be treated by a physician.

Eye contact: Rinse immediately with plenty of water. Do not rub eye. Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes and get medical attention.

Ingestion: Rinse mouth thoroughly with water. Give a few small glasses of water or milk to drink. Stop if the affected person feels sick as vomiting may be dangerous. Never give anything by mouth to an unconscious person. Place unconscious person on their side in the recovery position and ensure breathing can take place. Keep affected person under observation. Get medical attention if symptoms are severe or persist.

Indication of any immediate medical attention and special treatment needed: Treat symptomatically.

Environmental precautions: Prevent from entering into soil, ditches, sewers, waterways and/or groundwater. Spills or discharge to natural waterways is likely to kill aquatic organisms.

Personal precautions, protective equipment and emergency procedures in case of accidental release measures: Evacuate area.

Keep upwind of spill. Ventilate area of leak or spill. Only trained and properly protected personnel may be involved in clean-up operations. Use appropriate safety equipment.

Methods and materials for containment and cleaning up: Avoid making contact with spilled material. When cleaning up a spill always wear the appropriate protective equipment, including respiratory protection, gloves and protective clothing. A self-contained breathing apparatus or respirator and absorbents may be necessary, depending on the size of the spill and the adequacy of ventilation.

Small spills: Wear the correct protective equipment and cover the liquid with absorbent material. Collect and seal the material and the dirt that has absorbed the spilled material in polyethylene bags and place in a drum for transit to an approved disposal site. Rinse away the remaining spilled material with water to reduce odour and discharge the rinsate into a municipal or industrial sewer, not into a natural waterway.

Large spills: In case of nasal and respiratory irritation, vacate the room immediately. Personnel cleaning up should be trained and equipped with a self-contained breathing apparatus, or an officially approved or certified full-face respirator equipped with an organic vapour cartridge, gloves, and clothing impervious, including rubber boots or shoe protection.

This biocidal product, when being disposed of in its unused and uncontaminated state should be treated as a hazardous waste according to Directive 2008/98/EC of the European Parliament and of the Council of 19 November 2008 on waste and repealing certain Directives (OJ L 312, 22.11.2008, p. 3). Any disposal practices must be in compliance with all national and provincial laws and any municipal or local by-laws governing hazardous waste.

Do not dump into any sewers, on the ground, or into any body of water. Avoid release to the environment.

High-temperature incineration is an acceptable practice.

Containers are non-refillable. Do not reuse or refill the containers. Containers should be triple or pressure rinsed with water promptly after they are emptied. They can then be offered for recycling or reconditioning for biocidal products, or they can be punctured and disposed of in a sanitary landfill or by other procedures approved by national and local authorities. Send waste liquid from rinsing of used containers to an approved waste handling facility.

Store in a cool, well ventilated area.

Keep this product in the original container tightly closed.

Container must be stored and transported in an upright position to prevent spilling the contents.

Keep away from direct sunlight.

Do not freeze.

Store below 30 °C.

The shelf-life is 12 months (unopened).

For use only on visibly clean surfaces. Cleaning prior to disinfection is required. Physically remove contaminants from the surface before disinfection using a suitable cleanroom mop/wipe and a recommended wiping technique for optimum contamination control.

Pour the product into a container and then mop onto the surface.

Ensure the surface is uniformly covered with the product and leave for the required contact time indicated to kill bacteria, fungi, yeast and bacterial spores. Do not apply more than 50 ml/m².

Leave for required contact time and wipe to dry afterwards. For use at room temperature (20 ± 2 °C).

Suitable cleanroom wipe and mop materials should be used in order to minimise interaction with the product.

Used wipes must be disposed in a closed container.

Wear protective chemical resistant gloves and eye protection during product handling phase (glove material to be specified by the authorisation holder within the product information).

A protective coverall which is impermeable for the biocidal product shall be worn (coverall material to be specified by the authorisation holder within the product information).

Application of technical or engineering controls to remove airborne residues is mandatory (e.g. room ventilation or local exhaust ventilation (LEV)) during product application. A minimum ventilation rate of 100 air change per hour is mandatory.

Technical or engineering controls to remove airborne residues is mandatory (e.g. ventilation or LEV) before operatives are permitted to enter into treated areas after surface disinfection. Where necessary, a waiting restriction of sufficient duration must be set to allow time for the removal of airborne residues.

Inhalation: Move affected person to fresh air and keep warm and at rest in a position comfortable for breathing. Maintain an open airway. Loosen tight clothing such as collar, tie or belt. When breathing is difficult, properly trained personnel may assist affected person by administering oxygen. Get medical attention. Place unconscious person on their side in the recovery position and ensure breathing can take place.

Skin contact: It is important to remove the substance from the skin immediately. Rinse immediately with plenty of water. Continue to rinse for at least 15 minutes and get medical attention. Chemical burns must be treated by a physician.

Eye contact: Rinse immediately with plenty of water. Do not rub eye. Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes and get medical attention.

Ingestion: Rinse mouth thoroughly with water. Give a few small glasses of water or milk to drink. Stop if the affected person feels sick as vomiting may be dangerous. Never give anything by mouth to an unconscious person. Place unconscious person on their side in the recovery position and ensure breathing can take place. Keep affected person under observation. Get medical attention if symptoms are severe or persist.

Indication of any immediate medical attention and special treatment needed: Treat symptomatically.

Environmental precautions: Prevent from entering into soil, ditches, sewers, waterways and/or groundwater. Spills or discharge to natural waterways is likely to kill aquatic organisms.

Personal precautions, protective equipment and emergency procedures in case of accidental release measures: Evacuate area.

Keep upwind of spill. Ventilate area of leak or spill. Only trained and properly protected personnel may be involved in clean-up operations. Use appropriate safety equipment.

Methods and materials for containment and cleaning up: Avoid making contact with spilled material. When cleaning up a spill always wear the appropriate protective equipment, including respiratory protection, gloves and protective clothing. A self-contained breathing apparatus or respirator and absorbents may be necessary, depending on the size of the spill and the adequacy of ventilation.

Small spills: Wear the correct protective equipment and cover the liquid with absorbent material. Collect and seal the material and the dirt that has absorbed the spilled material in polyethylene bags and place in a drum for transit to an approved disposal site. Rinse away the remaining spilled material with water to reduce odour and discharge the rinsate into a municipal or industrial sewer, not into a natural waterway.

Large spills: In case of nasal and respiratory irritation, vacate the room immediately. Personnel cleaning up should be trained and equipped with a self-contained breathing apparatus, or an officially approved or certified full-face respirator equipped with an organic vapour cartridge, gloves, and clothing impervious, including rubber boots or shoe protection.

This biocidal product, when being disposed of in its unused and uncontaminated state should be treated as a hazardous waste according to Directive 2008/98/EC of the European Parliament and of the Council of 19 November 2008 on waste and repealing certain Directives (OJ L 312, 22.11.2008, p. 3). Any disposal practices must be in compliance with all national and provincial laws and any municipal or local by-laws governing hazardous waste.

Do not dump into any sewers, on the ground, or into any body of water. Avoid release to the environment.

High-temperature incineration is an acceptable practice.

Containers are non-refillable. Do not reuse or refill the containers. Containers should be triple or pressure rinsed with water promptly after they are emptied. They can then be offered for recycling or reconditioning for biocidal products, or they can be punctured and disposed of in a sanitary landfill or by other procedures approved by national and local authorities. Send waste liquid from rinsing of used containers to an approved waste handling facility.

Store in a cool, well ventilated area.

Keep this product in the original container tightly closed.

Container must be stored and transported in an upright position to prevent spilling the contents.

Keep away from direct sunlight.

Do not freeze.

Store below 30 °C.

The shelf-life is 12 months (unopened).

See Use-specific instructions for use.

See Use-specific risk mitigation measures.

See, where specific to the use, the particulars of likely direct or indirect effects, first aid instructions and emergency measures to protect the environment.

See, where specific to the use, the instructions for safe disposal of the product and its packaging.

See, where specific to the use, the conditions of storage and shelf-life of the product under normal conditions of storage.