OpenLegislation

Paragraph 3

Original text. Later amendments are not shown.

(1)

The cutter or cutters of every horizontal milling machine shall be fenced, by a strong guard properly adjusted to the work, which shall enclose the whole cutting surface except such part as is necessarily exposed for the milling operations.

(2)

The guard shall either:—

(a)

be provided with adequate side flanges; or

(b)

extend on each side of the cutter or cutters to the end of the arbor, or to the arbor support, or to a distance of not less than half the diameter of the cutter,

provided that sub–paragraph (2) of this paragraph shall not apply to cutters used for face milling.