Regulation 42 E1

England, Wales and Scotland

(1)

The manufacturer must follow one of the following conformity assessment procedures referred to in F1Schedule 1A to these Regulations according to the category in which the equipment is classified—

(a)

Category I: Module A;

(b)

Category II: Module A2; or, at the choice of the manufacturer, Module D1; or Module E1;

(c)

Category III: Modules B (design type) + D; or, at the choice of the manufacturer, Modules B (design type) + F; or Modules B (production type) + E; or Modules B (production type) + C2; or Module H;

(d)

Category IV: Modules B (production type) + D; or, at the choice of the manufacturer, Modules B (production type) + F; or Module G; or Module H1.

(2)

The manufacturer may also choose to apply one of the procedures which apply to a higher category, if available.

Annotations

Textual amendments

F1: Words in reg. 42(1) substituted (E.W.S.) (31.12.2020) by The Product Safety and Metrology etc. (Amendment etc.) (EU Exit) Regulations 2019 (S.I. 2019/696), reg. 1, Sch. 24 para. 27 (with Sch. 24 para. 41) (as amended by S.I. 2020/676, regs. 1(1), 2); 2020 c. 1, Sch. 5 para. 1(1)

Extent

E1: This version of this provision extends to England and Wales and Scotland only; a separate version has been created for Northern Ireland only