Division 4.1.5.2 Procedure and requirement
Coatings shall be evaluated using the following test methods:
- (a)
Adhesion strength in accordance with ISO 4624, using method A or B as appropriate. The coating shall exhibit an adhesion rating of 4;
- (b)
Flexibility in accordance with ASTM D522, using Method B with a 12,7 mm mandrel at the specified thickness at – 20 °C. Test samples shall be prepared in accordance with ASTM D522. There shall not be any visually apparent cracks;
- (c)
Impact resistance in accordance with ASTM D2794. The coating at room temperature shall pass a forward impact test of 18 J;
- (d)
Chemical resistance in accordance with ASTM D1308. The test shall be conducted using the open spot test method and 100 hours exposure to a 30 per cent sulphuric acid solution (battery acid with a specific gravity of 1,219) and 24 hours exposure to a polyalkalene glycol, e.g. brake fluid. There shall be no evidence of lifting, blistering or softening of the coating. The adhesion shall meet a rating of 3 when tested in accordance with ASTM D3359. This test is not necessary if a test is undertaken in accordance with section 4.2.6.;
- (e)
Light and water exposure in accordance with ASTM G154, using an exposure of 1 000 hours. There shall be no evidence of blistering. The adhesion shall meet a rating of 3 when tested in accordance with ISO 4624. The maximum gloss loss allowed is 20 per cent;
- (f)
Salt spray exposure in accordance with ASTM B117, using an exposure of 500 hours. Undercutting shall not exceed 3 mm at the scribe mark. There shall be no evidence of blistering. The adhesion shall meet a rating of 3 when tested in accordance with ASTM D3359;
- (g)
Resistance to chipping at room temperature using the ASTM D3170. The coating shall have a rating of 7A or better, and there shall not be any exposure of the substrate.