Division 1 General procedureF1

The Member States authorities shall verify one single unit of the model.

The model shall be considered to comply with the applicable requirements if:

1. (a)

   the values given in the technical documentation pursuant to point 2 of Annex IV to Directive 2009/125/EC (declared values) and, where applicable, the values used to calculate these values are not more favourable for the manufacturer, importer or authorised representative than the results of the corresponding measurements carried out pursuant to paragraph (g) thereof;

2. (b)

   the declared values meet any requirements laid down in this Regulation and any product information published by the manufacturer, importer or authorised representative does not contain values that are more favourable for the manufacturer, importer or authorised representative than the declared values;

3. (c)

   when the Member State authorities test the unit of the model, the determined values (the values of the relevant parameters as measured in testing and the values calculated from these measurements) comply with the respective verification tolerances as given in Table 3; and

4. (d)

   when the Member State authorities check the unit of the model, it complies with the functional requirements and the requirements on repair and end-of-life aspects.